Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Dismantle GNU souce using Autotools

Status
Not open for further replies.
R

rockskuller

Junior Member level 2
Joined
Apr 7, 2009
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,408
I have to dismantle a GNU source code of size nearly 20MB. In order to do so I need information of compile time settings, library linked with it etc. Normally the configure and makefile contains these information. But it is difficult to extract it manually. How to make use of autotools to perform this information extraction process?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top