Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

dipole antenna with balun

Status
Not open for further replies.

shahid78

Full Member level 5
Joined
Jul 29, 2006
Messages
289
Helped
34
Reputation
68
Reaction score
14
Trophy points
1,298
Activity points
3,290
we normally in CST MWS as well as in HFSS we use wire port to excite halfwave dipole in the centre.
now i have constructed a dipole and have used coaxial cable as feed transmissin line
as coaxial is unbalanced line and dipole is balanced so i have to design balun as well.

now when i simulated this actual dipole along with balun i am not getting the results as expected.
i am using lambda by 4 balun

if anyoner simulated such kind of dipole with balun i would like to have their comments on this

thanks
 

xxgcatz

Member level 2
Joined
Feb 19, 2004
Messages
49
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
492
I think the software perhaps is not good at siumalting the balun. And the ambda by 4 balun is very easy to make in practice. You can make it and test it.
My antenna level is not high,but i only want to say sth.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top