Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The picture is small but if I read it correctly, the peak to peak voltage is only ~400mV so you probably don't have enough voltage to drive the diodes into full conduction. As pointed out, you should put some kind of resistive load on the bridge output or you will see the effects of stray capacitance and the scope probes distorting the waveform.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
