Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It is a buffer follower. It acts just an op-amp would in the same configuration. It is used to clean up a digital signal.
Lets say that a digital driver sets its output at 5V. Then due to the traces, or due to wires, the volatge drops. If it drops far enough, then a reciever (another gate) might not respond. So, this is placed to raise the voltage back up. Take a look at buffer follower for op-amps. Red
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.