Kunna
Newbie level 5
Hey,
I was wondering how to design a differential PA, so basically you have two common source amplifiers which are connected to a transformer with a center tap.
How do you do load pull on a differential pair to know the optimum load impedance for the transistor? Do you just use one single transistor instead?
Once you have you optimal impedance, how does the transformer transform the 50 Ohm load?
I was wondering how to design a differential PA, so basically you have two common source amplifiers which are connected to a transformer with a center tap.
How do you do load pull on a differential pair to know the optimum load impedance for the transistor? Do you just use one single transistor instead?
Once you have you optimal impedance, how does the transformer transform the 50 Ohm load?
Last edited by a moderator: