Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

differential Amplifier built by TL061 op-amp...IZT CORRECT??

Status
Not open for further replies.
D

darlling5147

Member level 3
Joined
Jun 28, 2006
Messages
55
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,632
i need to plot a graph by using the voltage differences between 2 signals. I have built a sensor to obtain the 2 signals and now I need to measure the voltage different by using Differential Amp.

by using TL061, which is op-amp amplifier, izt I just need to input 2 obtained signals into Pin 2 and 3 and get the output signal at Pin 6? DO i need to connect any resistor/capacitor?

THX
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top