Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Different track width in a net in Layout Plus.

Status
Not open for further replies.

kashimonga

Junior Member level 1
Joined
Sep 8, 2005
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,427
Hi all,

I use Layout Plus 10.3.0. in some cases we need to have a track that has a wide width (e.g. 60 mils for VCC or GND). but we may have components that have low pad spacing such as SMD ICs. if we want to route these tracks to these components, we may route the track with wide width (60 mils) to a point near the component pin and then change the width property to a fewer value (10 mils) and continue routing to the component pad with this ne width.

Is it possible to tell to Layout Plus to do this width change automatically in autoroute proccess?

I know that SPECCTRA (Allegro) does this.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top