Difference between hand analysis and simulator results ?

Status
Not open for further replies.
H

hoo

Newbie level 5
Joined
Apr 19, 2013
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,333
Hi , I tried to design common source amplifier by hand analysis and obtained certain values of circuit parameter , then put these parameters into cadence simulator , after simulation I noticed that there is a big difference between the results obtained from hand analysis and others obtained from cadence simulator , what is the problem and how to solve it ?
 

Generally the simulator uses more complex and accurate equations to determine the circuit operation so it is likely more accurate than your hand calculation. If you post your results for both I can perhaps comment further.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…