Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Difference between Blind and Buried vias?

Status
Not open for further replies.

jayasuryan

Member level 5
Joined
Jul 12, 2006
Messages
86
Helped
5
Reputation
10
Reaction score
3
Trophy points
1,288
Activity points
1,820
unterschied blind und buried via

Hello.......
Anybody tell the difference between Blind and Buried vias?
With Thanks
 

Sakr

Member level 2
Joined
Jul 9, 2005
Messages
43
Helped
11
Reputation
22
Reaction score
5
Trophy points
1,288
Location
Cairo, Egypt
Activity points
1,533
blind vias are connecting a inner layer to either the top or bottom layer, and the other layer is blind as it doesn't see the via.

buried via is connecting two inner layers, without access to top or bottom layer.

that's different from the regular via that connect top layer to bottom layer and pass through all inner layers.

Regards,
Sakr

66_1163665762.gif
 

vamanan

Full Member level 2
Joined
Aug 9, 2005
Messages
135
Helped
10
Reputation
20
Reaction score
4
Trophy points
1,298
Location
India the Great
Activity points
2,286
Hi jayasuryan,
You could have googled before posting this.
Blind vias are via holes which are formed to connect the outer circuit with inner layers, but DO NOT go through the entire board
Buried vias are via holes used to connect inner layers and are not visible in the outer layers.
I hope you understood now.
The following web page will help you.
Code:
http://www.cadint.se/manual/pcbvia.hole.via.symbol.htm
Cheers
 

dunn

Full Member level 3
Joined
Apr 12, 2001
Messages
155
Helped
22
Reputation
44
Reaction score
7
Trophy points
1,298
Activity points
1,276
jayasuryan said:
Hello.......
Anybody tell the difference between Blind and Buried vias?
With Thanks


In the case of multilayer boards (e.g. 4 layers)

Blind via = Via goes from one of the outer layers and does not appear the other side.

Buried via = via sandwiched between the outer layers and can not be seen.

Hope this helps.
 

neena

Member level 4
Joined
Feb 6, 2006
Messages
77
Helped
9
Reputation
18
Reaction score
4
Trophy points
1,288
Location
pluto
Activity points
1,762
Through via -An interconnection between the top and the bottom layer of a
PCB. Through vias can also provide interconnections to innerPCB layers.

Blind via -An interconnection from the top or bottom layer to an inner
PCB layer.

Embedded via or buried via -An interconnection between any number of inner PCB layers.


Blind vias and through vias are used more frequently than embedded vias.


Regards
Neena
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top