Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Designing of boost converter controller using Perturb and observe (P&O) Technique

Status
Not open for further replies.

eng_ema

Newbie level 6
Newbie level 6
Joined
Dec 19, 2010
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
egypt
Visit site
Activity points
1,371
Hello Everyone,

i am designing a boost converter analog controller using P&O technique
i need an analog circuit works as accumulator instead of integrator ... because the integrator slop changes slightly and it make problems in my design

so any on can help me
also if any one used an integrator before can tell me who to optimize its parameter??

Thanks in advance
 

Re: Designing of boost converter controller using Perturb and observe (P&O) Technique

Assuming you'll be using an opamp integrator since you're going analog, the equation is
\[V_{out} = -\frac{1}{RC}\int_0^t V_{in}(t) dt\]
Hence the integrator can be most easily tweaked by choosing a fitting order of magnitude for C and then adjusting R appropriately.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top