aryajur
Advanced Member level 3
- Joined
- Oct 23, 2004
- Messages
- 793
- Helped
- 124
- Reputation
- 248
- Reaction score
- 37
- Trophy points
- 1,308
- Location
- San Jose, USA
- Activity points
- 7,788
Can anyone give me a few useful tips about hw to go about designing inductors in ASITIC. Right now I just use optsq to get a square inductor and try playing with the parameters to get a good Q for the inductor I need. Also many times it cannot come up with a solution.
So is there any starting point, or rough equation which can tell me how many turns should I pur, what should be the width, spacing and area estimated so that I can begin with the design.
Also if anyone can give me tips on how to improve the quality factor of the inductor, it will be helpful
So is there any starting point, or rough equation which can tell me how many turns should I pur, what should be the width, spacing and area estimated so that I can begin with the design.
Also if anyone can give me tips on how to improve the quality factor of the inductor, it will be helpful