on the above post i can get them values from a battery technical sheet? i was going to base the design off of this smart battery charger https://obrazki.elektroda.pl/2945700000_1450538576.gif which uses an window comparator , with op-amps as comparators or if i can't get this to work just make them out of transistors.
can i use that above circuit in parrallel with the charging circuit , have the main pulsing circuit on the battery and than the led circuit on the battery, but because its also hooked up to the charging circuit, and the problem is the voltage would be more than 1.5 volts. So how could i integrate that LED circuit with my pulsating charging circuit, so when the led light turns on when the battery is at the right voltage?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?