Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

designed power meter using arm+ad73360

Status
Not open for further replies.

libang2001

Junior Member level 2
Junior Member level 2
Joined
Dec 6, 2001
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
92
ad73360 arm

i want designed the three-phase power meter using arm and ad73360,somebody can give me help at dsp
 

Hi,



Instead of using ad73360, I would like to suggest you the usage of the ADE7753 (or its poly-phase counterpart).

This family of ICs has a built-in "dsp engine" that does all the "dsp computation related to energy/power measuring" for you. Once using it, the only thing to do is to read its registers of energy/power measurements, what can be done by means of a SPI interface.


Best regards.
 

the meter must calculate 1-15's harmonious
 

libang2001 said:
the meter must calculate 1-15's harmonious

It is not a problem because you can get the samples of the current and voltage waveforms that are used by the IC. You may use them to calculate the harmonics.

You may also use the CS5463 IC from CirrusLogic.

Best regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top