Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello friend i have to design this patch using ie3d. i have to cut out the black shaded part from the rectangle as i m just learning ie3d thats why dont know to cut the shaded part. plz someone help me in this i wil b very thank full to u
Open Mgrid
1) Go to Entry>Rectangle
Draw Patch
2) Go to Advanced Edit> Dig Rectangular hole
Dig a big hole
3) Go to MEntry>Rectangle
Now draw internal patch
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
