If I asked you, "what do you think the most straight forward approach to designing a pure sinewave inverter to convert 12VDC into 230VAC 50Hz is?"
Getting a bandpass filter for 50Hz that can handle significant power levels is not trivial.
The "pdf document" you have referred to also contains many inaccuracies. Better to refer to "application notes"
The priorities are simple and cheap, not good performance and reliable.
... if I am not mistaken a MCU based design gives greater and easier access to the possibility to adjust parameters such as switching frequency, duty cycle, dead-time and so on...
For a real cake, a very simple robust analog solution will win hand down for cost, simplicity, and robustness.
... and holding a committee meeting about some interrupt.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?