waveplumber
Junior Member level 3
Hi all,
I am wondering how to define a stripline in HFSS. Suppose I have a strip sandwiched between two ground planes, how do I defined a single lumped port for this stripline set up? Do I have to draw two integration lines originating from each of the ground planes? Do I need more than one mode to define the port in this case?
Thanks for your insight,
Waveplumber
I am wondering how to define a stripline in HFSS. Suppose I have a strip sandwiched between two ground planes, how do I defined a single lumped port for this stripline set up? Do I have to draw two integration lines originating from each of the ground planes? Do I need more than one mode to define the port in this case?
Thanks for your insight,
Waveplumber