Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

DC motor control with L6384

Status
Not open for further replies.

stefan_d6

Newbie level 4
Joined
Dec 31, 2005
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,344
l6384

I built a scheme that controls the speed of DC motor through the PC, see the circuit. Everything was fine with power supply of the motor up to 30V. When I applied 200V everything burned. I didn't understand what happened - the two MOSFETs IRFP260N, the MOSFET driver L6384 and the uC are out of order.
I didn't apply a load but this couldn't be a reason for burning.

Can someone post working circuit of L6384 or DC motor control circuit, 200V, 10A

I attach the circuit and the PCB of my masterpiece.

https://obrazki.elektroda.pl/73_115...ki.elektroda.pl/73_1159902350_thumb.jpg[/img]

[/url]
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top