Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Data Switch - How to convert serial data to Ethernet Data?

Status
Not open for further replies.
R

rmanze

Newbie level 1
Newbie level 1
Joined
May 20, 2011
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
Hello Guys,

I would like to build a data switch to connect between multiple serial device through the computer using the Ethernet port.
The IP address can be set to this Data switch and then can be connected to the switch or router using the Ethernet port so this data switch can be access using WAN and controlling the serial device.

Can anyone help me how can i start first?
Is there any simple module or schematic diagram i can start learn?
 

Do you mean Ethernet to serial device? All major manufacturers have controllers that can do the job, e.g. Microchip PIC18F97J60, ARM based processors from ST and others. Most vendors have application notes, software IP stacks, development boards to get started as well. You could even buy off-the-shelf Ethernet to serial modules
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top