AmmarAli
Junior Member level 1
Hi,
I am new to this forum and also new with using CST microwave studio.
I have a question.
When calculating port extension coefficient, sometimes I got minimum and maximum value for K, why this happens ? is there something wrong with the design ? If not, which one I should select because there is deference between the results when simulating with min and max K.
Also other question
Can I use parameter swap for K and how?
Thanks in advance.
I am new to this forum and also new with using CST microwave studio.
I have a question.
When calculating port extension coefficient, sometimes I got minimum and maximum value for K, why this happens ? is there something wrong with the design ? If not, which one I should select because there is deference between the results when simulating with min and max K.
Also other question
Can I use parameter swap for K and how?
Thanks in advance.