Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CST microwave studio; Steady State Energy not met Warning

Status
Not open for further replies.

budder8818

Junior Member level 3
Joined
Sep 15, 2010
Messages
25
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
New Jersey, USA
Activity points
1,476
What is the warning: "Steady State Energy Criterion Not met. Maximum pulse widths simulated. Solver Stopped" mean? Any input is welcomed

Thanks
 

Probably you're analyzing a high-resonant structure so the energy was still entrapped in the structure when the solver stopped.
Try to go to: "Transient Solver--->Specials---->Steady State" and set a higher value in the box relative to "Maximum number of pulses".
If the simulation was too slow, you could try to use the AR-filtering too or instead the frequency solver.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top