Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CST Microwave Studio - how to simulate characteristic impedance

Status
Not open for further replies.

bisonriver

Newbie level 3
Joined
Oct 30, 2010
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,302
Hi,
I’m using CST2009 Microwave Studio to simulate transmission line characteristic impedance. The scenario is to have a pair of copper wires that are about 1 inch above the earth ground plate. Additionally, I’d like to see the characteristic impedance of a shielded twist pair (STP) with the shield connected to earth ground. Currently I’m using the “Waveguide Ports” on simple 2 wires without problem. How do I add an earth-grounded shield? That is, I can draw a metallic shield, but how do I specify it to be earth grounded?

Thanks for answering my question.
B. Riverton
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top