Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[CST Microstripes] No. of Time Step

Status
Not open for further replies.
F

freqzt

Advanced Member level 4
Joined
Sep 13, 2006
Messages
117
Helped
18
Reputation
36
Reaction score
14
Trophy points
1,298
Activity points
1,988
cst microstripes

To all of you that have experience with CST Microstripes.

Before we run the simulation, we should input the no. of time step at model parameters. The question is, what is the appropriate no. of time step to simulate an antenna? The default no. is 32xlargest dimension. If the antenna dimension is large enough, the simulation will time consuming. From the manual it said that for antenna simulation, the no. of time step can be set less than 20xlargest dimension but not specific, 10x? 5x?

Please help me.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top