Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST - How to model a flex-cable

Status
Not open for further replies.
Z

zionico90

Member level 2
Member level 2
Joined
Nov 28, 2013
Messages
48
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Visit site
Activity points
369
Hi,

I have CCD and Amplifier that are connected by a Flexi Cable with 37 microType-pin Connector.
The EM target is to model the system with CST CABLE STUDIO.

CCD output impedance is 500 ohm
Amplifier External Load is 1oKohm or higher

Which is the impedance of each in-pin?Is 500ohm or 500/37 ohm? And for the output impedence?

Thank you
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top