Mke28
Newbie level 5
I added a new excitaion signal by importing ASCII file
BUt the cst gives this below and suddenly aborts :
The current settings will lead to an extremely long simulation time.
You may improve the simulation speed by:
1. checking the frequency range and units settings
2. reducing the simulation duration
3. checking the mesh to avoid very small mesh steps
Can anybody help me plzzzzz?
BUt the cst gives this below and suddenly aborts :
The current settings will lead to an extremely long simulation time.
You may improve the simulation speed by:
1. checking the frequency range and units settings
2. reducing the simulation duration
3. checking the mesh to avoid very small mesh steps
Can anybody help me plzzzzz?