Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST contour plot problem, same point give different values at different view

Status
Not open for further replies.

ygxy

Newbie level 1
Joined
Jul 11, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
I am doing some simulation for a coplanar waveguide. After CST finished the calculation, I use the plot tool in CST to give me contour plot of the Abs value of the H field. To my surprise, if I plot field on the z=10 plane the plot shows the field range is from 200-1500A/m, but if I plot on the y=0 plane the field is from 300-3000A/m. Since the two plane have a intersection line, I use mice to pick the field for a same point, it gives me different values for the above different cases, which mean in the programe the field at same point is different if you look from different directions.
I am really confused now.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top