SphinX
Advanced Member level 3
crossworks wiggler
Salam,
I have installed CrossWorks v1.4 as ARM C compiler.
My hardware consist of MCB2100 Evaluation board Connected to wiggler debugger interface.
I can compile my codes and program the ARM LPC2138 fine.
Running and stoping the code is working too.
But my problem is in the debugging.
Only the breakspoint work fine, The other debugging options such as Step into is not working, I don't why :-( ?
Do you have a solution ?
Thanks very much
Salam,
I have installed CrossWorks v1.4 as ARM C compiler.
My hardware consist of MCB2100 Evaluation board Connected to wiggler debugger interface.
I can compile my codes and program the ARM LPC2138 fine.
Running and stoping the code is working too.
But my problem is in the debugging.
Only the breakspoint work fine, The other debugging options such as Step into is not working, I don't why :-( ?
Do you have a solution ?
Thanks very much