Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cross selecting component between Capture and Allegro

Status
Not open for further replies.

damian_s

Member level 1
Joined
Aug 18, 2005
Messages
34
Helped
0
Reputation
2
Reaction score
0
Trophy points
1,286
Location
Indonesia
Activity points
1,545
Hi all,

I want to try to do manual placement in Allegro 15.2 by cross selecting component(s) in Capture schematic. Does anybody know how to do it?

Thanks.
 

Hi,

In Capture Enable Intertool Communication. Netlist to Allegro now you have cross selection between two.

Regards,

Majnoon
 

    damian_s

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top