Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CPW open end stub and other discontinuities

Status
Not open for further replies.

icpinu

Junior Member level 2
Junior Member level 2
Joined
Nov 26, 2010
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,450
Hi,

I have been reading a lot on CPW design from many sources but I don't know how to design an open end stub or a T on CPW. I can use ADS or CST for the design but I don't know where to start to select the dimensions of the stub since many equations take into account the gap but not the actual lenght of the stub.

Any guidance is much appreciated.

Regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top