Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CPLD reprogramming of Xess board

Status
Not open for further replies.
Al Farouk

Al Farouk

Full Member level 4
Joined
Jan 13, 2003
Messages
191
Helped
16
Reputation
32
Reaction score
16
Trophy points
1,298
Location
Egypt
Activity points
1,854
I'm using Xess board, some of its FPGA chip are used during Prallel port programming so to use this pins as general I/O port the CPLD should be reprogrammed to change the Prallel port/FPGA interface. dos any one can help by which design the CPLD should be reprogrammed.

thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top