pavan garate
Member level 3
I'm using TANNER v14.1 & TSPICE. I have designed a ckt in S-Edit.
1) I want to convert the schematic into a good quality TIFF image. I used the option of "Capture Window" but the image quality is very poor. What should I do?
2) After simulating the ckt using TSPICE, I want to find the estimated chip area. How to find it?
1) I want to convert the schematic into a good quality TIFF image. I used the option of "Capture Window" but the image quality is very poor. What should I do?
2) After simulating the ckt using TSPICE, I want to find the estimated chip area. How to find it?