Re: Conversion to binary, how to? in C and matlab?? help me
Anno said:
Ok...in plainer and simpler english?
You want to send or "copy" a data file over a wifi or serial?
link to a remotedestination, in C, C++ or Matlab.
If I understand it correctly, this is not so bad.
since it is not the programmer's but the operating system's
job to do the actual transfer and breakup into bits and bytes to
send over a communication channel, may it be serial or wifi (non serial).
Sorry, but i want to point out some thing
I'm not a programmer, I will build my own Tx and Rx (Whatever how),
then i want to connect the system as:
i have a Tx and Rx,
i have also a PC file (any type even txt file)
i want to convert it over any port (i said serial as i think it will be simple) to bit stream
this bit stream have to go from one PC to the Tx to air, to the Rx to the other PC .. all via any port
I dont' care what i will use, Matlab, C or even Visual Basic...
Link will be wireless one, so a protocole may be a must in this case to enhance BER and correct or detect errors, (but it's not important right now)
I will build the Tx and Rx not use them ready made modules ... and data rate is not an issue now...
thanks in advance,
Ahmad,