liamv
Newbie level 3
Hi long story short I want to control a simple 3-18V DC Motor using the output pins from my UP1 FLEX10K board.
I have the VHDL code ready to go but obviously the board only outputs a 5V High, idaelly i need 12V dor the motor application.
The motor has a maximum current draw of 600 mA, is this too much to say, code the board to connect pins A (12v reg) and B (motor positive) to switch it on?
Should I use a darlington array?
Thanks for your help
I have the VHDL code ready to go but obviously the board only outputs a 5V High, idaelly i need 12V dor the motor application.
The motor has a maximum current draw of 600 mA, is this too much to say, code the board to connect pins A (12v reg) and B (motor positive) to switch it on?
Should I use a darlington array?
Thanks for your help