Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
PIC microcontroller (and in general: microcontrollers) is fast enough to control several motors (loads) ..
If you know how to control one, and here you can find out how to do it:
"Tips ‘n Tricks DC Motor Control" https://ww1.microchip.com/downloads/en/DeviceDoc/41233A.pdf
use PIC with sufficient number of pins to control 3 dc motors in required configuration, for example, brushed DC motors: low or high side drive - one direction (one pin per motor) or H-bridge drive - CW and CCW (4 pins per motor) ..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
