I want to make line follower robot I am using 8051 micro controller I have c code keil software i am confused about programer I don't want to buy programmer I want to make hardware myself I want to ask can i need to use software for programmer circuit I think no but I am asking for my understanding
This is what you want.
You can make it by your own.
You need Flash Magic (it's an open source software for student purpose). So download it from here https://www.flashmagictool.com/
Do post here if you've any other queries.
All the best
(Updated) this circuit will work with at89c51 as well with p89v51rd2 and also with other 8051 ICs...
This is what you want.
You can make it by your own.
You need Flash Magic (it's an open source software for student purpose). So download it from here https://www.flashmagictool.com/
Do post here if you've any other queries.
All the best
(Updated) this circuit will work with at89c51 as well with p89v51rd2 and also with other 8051 ICs...
hello, jigar I am using at89c51 I read somewhere that ISP programmer is used for at89c51 Ic I want to ask Can I make this circuit with rs232 ttl ic and 4 cap
Ya you can do this by serial port and flash magic.... If you want to do this by USB then only you have to use usb driver ICs and FDTI drivers and so on...
As answered by Venkadesh_M you can do it for sure.
Go ahead.
And according to the hardware of the programmer is also flexible for almost all kind of 8051 ICs...
But I am waiting for the confirmation from nandhu015.