Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Complementary Split Ring Resonator Design in HFSS

Status
Not open for further replies.
S

srijan.rio

Member level 2
Joined
Mar 7, 2016
Messages
50
Helped
2
Reputation
4
Reaction score
1
Trophy points
8
Activity points
484
Hello everyone.

I am new in simulating SRR and CSRR based structures in HFSS. While trying to verify the paper "Compact Second-Order Bandstop Filter Based on Dual-Mode Complementary Split-Ring Resonator" by Ebrahimi et. al. , I was not getting proper results in S11 as well S21 values. I have attached the paper as well as my HFSS design. What am I doing wrong here? It would be really helpful if someone can look into it.

Regards.
 

Attachments

  • Verification.rar
    1.1 MB · Views: 126

Alright I found out what my mistake was. The wave port size was small so it didn't allow any propagating modes. I am now getting correct results by increasing the port to appropriate size.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top