Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Command confirmation IEC 870-5-104

Status
Not open for further replies.

dperez79

Member level 1
Joined
Feb 10, 2004
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
299
iec 870-5-104

Dear all,

I am receiving after a set-point command ( C_SC_NA_1 in IEC 870-5-104 protocol ) two confirmation messages with differents COTs (Cause of Transmission):
1- COT=7 -> Activation confirmation
2- COT=10 -> Activation termination.

And then these set points commands are not controlling the remote.

What does this COT=10 (Activation termination) means?
Why are we receveing this second confirmation messsage?

A lot of thanks,
Daniel P.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top