Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Combline filter design with ADS.

Status
Not open for further replies.

lindlt

Newbie level 5
Joined
Feb 7, 2012
Messages
9
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,337
Hi

I'm designing a combline filter in ADS using stripline and microstrip. Can someone please tell me why stripline need a 3 layer substrate (MLSUBSTRATE3) and microstrip a 2 layer substrate (MLSUBSTRATE2)?

Thanks
 

Hi lindt,

Stripline is buried inside the dielectric with two ground conductor above and below it. (3 layer substrate)
Microstrip is exposed to air and only have one ground conductor below it. (2 layer substrate)

Hope this helps,

Microwave123
 

hello i want to design combline transformer filter with equal diameter round rod plz help me and propose me refrences and plz send them to my email
mbanar.kntu@gmail.com
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top