Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

codevision playing funny

Status
Not open for further replies.

sina_extreme

Junior Member level 2
Joined
Nov 14, 2010
Messages
22
Helped
4
Reputation
8
Reaction score
4
Trophy points
3
Activity points
0
hi friends
my codevision is playing funny
when compiling it works perfect but when i try to build coff file it prompts an error page and says:
Error(s) occurred during assembly !
and then forwards me to an assembly page where there is a problem with an mcur parameter in the following line
.SET power_ctrl_reg=mcucr
what does this mean and how can I get rid of it
regards
sina

---------- Post added at 18:26 ---------- Previous post was at 16:45 ----------

I reinstalled the software
now It is playing another game
I have some old code and they work perfect on proteus
when I simply copy the codes into a new prohect and build them and put the out put at proteus, it starts to prompt 3000 warnings and errors !
this is another version of codevision
is there sth wrong with my PC ?
 

sina_extreme

Junior Member level 2
Joined
Nov 14, 2010
Messages
22
Helped
4
Reputation
8
Reaction score
4
Trophy points
3
Activity points
0
I also tried codevision 1.24 - 2.4 - 2.5
no results yet
proteus says: could not load source file 'my file.c'
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top