Clock Generation Block

omara007 · Jul 10, 2008

Hi folks

If I'm isolating all generated clocks in one module .. with the source highest speed clock as an input .. and the all the required generated clocks are outputs .. should I use any reset or enable signals in this block ? ..
Simply, the block will contain a counter and each generated slower clock will be toggling with some counts of this counter .. but should this counter have a reset ? .. and enable ?

koppolu1981 · Jul 11, 2008

Hi omara,
You need to have a reset in ur case also.
What will be the initial output of the counter if you do not assert reset...

Regards,
RamaMohan Rao K

omara007 · Jul 11, 2008

koppolu1981 said:
Hi omara,
You need to have a reset in ur case also.
What will be the initial output of the counter if you do not assert reset...

Regards,
RamaMohan Rao K

You are correct .. and even each generated clock should have a reset value .. but what about the enable ? .. would that be equivalent to clock gating for them ? ..

koppolu1981 · Jul 14, 2008

I think you should be using enable signal if your design needs it. The enable must be a functional signal. You must give enable as an input signal to the clock generation block if you are required to gate the clock in your design/ if you are clamping the clock.

- RamaMohan Rao K

Clock Generation Block

omara007

Advanced Member level 4

koppolu1981

Junior Member level 3

omara007

Advanced Member level 4

koppolu1981

Junior Member level 3

Similar threads

Clock Generation Block

omara007

Advanced Member level 4

koppolu1981

Junior Member level 3

omara007

Advanced Member level 4

koppolu1981

Junior Member level 3

Similar threads

Privacy & Transparency

Privacy & Transparency