[SOLVED] Clock edit function not working

hiii i am using PIC30F5011.

I have Written Clock edit function but its not working
i have three switches on RG12,RG0,RG1 pins
TRISGbits.TRISG12=1;
TRISGbits.TRISG0=1;
TRISGbits.TRISG1=1;


when i was press RG14 controller goes to clokedit function but its not going to switch function ..what did i wrong.can any one help or any other suggestion for writing Clockedit function

while(1)
{
if(PORTGbits.RG14)
{
Clockedit(); //Calling Clockedit function
}
}

void Clockedit(void)
{
unsigned int count=1;

while(count<=4)
{

switch(count)
{

case 1: MoveRight(14); // cursor position
if(PORTGbits.RG0 && ClockTime.Hours<24)
ClockTime.Hours++;
if(PORTGbits.RG1 && ClockTime.Hours>=0)
ClockTime.Hours--;
break;

case 2: MoveRight(17); // cursor position
if(PORTGbits.RG0==1 && ClockTime.Minutes<60)
ClockTime.Minutes++;
if(PORTGbits.RG1==1 && ClockTime.Minutes>=1)
ClockTime.Minutes--;
break;

case 3: MoveRight(20); // cursor position
if(PORTGbits.RG0==1 && ClockTime.Seconds<60)
ClockTime.Seconds++;
if(PORTGbits.RG1==1 && ClockTime.Seconds>=1)
ClockTime.Seconds--;
break;

case 4: Clock(); // calling for update clock

}
if(PORTGbits.RG14==1)
count++;
}
}

Maybe count value is exceeding value 4 and then switch is not executing. Put a debounce delay for if(PORTGbits.RG14) if it is a switch. Also replace

if(PORTGbits.RG0 && ClockTime.Hours<24)

with

if((PORTGbits.RG0) && (ClockTime.Hours<24))

hiiiii

thank you very much jayanth.devarayanadurga