Audioguru, BradtheRad thank you very much:smile:
Audioguru, i really liked your first message. It's very helpful. After that i looked at the internet and found this:
"TP4056 5V 1A Lithium Battery Charging Board Charger Module" (I'm adding a picture of it)
The given specs are these:
1. onboard chip TP4056
2. MINI USB onboard header, you can directly connect to the computer USB port charging
3. the charge sheet can also be (IN + and IN-) pin power supply
4. set aside TEMP pin interface can be used as battery temperature detection
5. the input voltage: 4V-8V, output maximum charging current: 1000mA
6. the charging indicator light D1, D2 light charging is completed
7. PCB board size: 37.3 (mm) x15 (mm)
I learned that TP4056 is a constant current / constant voltage linear charger. So this charger module is fine for efficient charging right?
But i have one question that if we use a 1000 mA, 5V charger instead of 500mA charger, would it be still allright? I can easily find a quality USB 1000mA charger, but finding a quality 500mA charger is not very easy in my country.
There is one data about TP4056:
"programmable charge current, up to 1000mA"
But i don't know if the "TP4056 5V 1A Lithium Battery Charging Board Charger Module" is programmed to charge the battery at 1000 mA.
In the specs it says "output maximum charging current: 1000mA". This value is if we want to use the battery+module to charge sth else right? I mean not to charge my battery but charge other stuff?
Last thing:smile:, i will use the charging circuit plus the battery has a protection circuit. Could it be a possible "confliction" between the protection circuit and the charging circuit?
Thank you very much Audioguru and others!