Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Changing parameters in Proteus

Status
Not open for further replies.

adi0803199

Advanced Member level 4
Joined
Mar 23, 2013
Messages
101
Helped
16
Reputation
32
Reaction score
16
Trophy points
1,298
Activity points
1,900
I am using Proteus software for simulating basic electronics circuit.I can't figure out how to change the transistor parameters (i.e) hfe or \[\beta\] . I also don't know how to plot parameters sweep in Proteus.Any help in this regard would much appreciated.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top