Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Cell info display (at=cscb) using at commands

Status
Not open for further replies.

avineshb006@gmail.com

Member level 3
Joined
Dec 30, 2011
Messages
67
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,288
Location
Chennai
Activity points
1,706
Hi All

I need an AT Command, to get the cell info display in SIM900 Modem,
i am trying to get this by using following commands,

AT+CMGF=1
>OK
AT+CNMI=0,0,2,0,0
>OK
AT+CSCB=0,"50","1"
>ERROR

but in the cscb command throws an error from my modem, Pleas tell me is there any other configuration i need to do in this AT commands, if so please help me,
 

Enable extended error messages to know why the command fails.
 

Hello FvM

Thanks for your reply, i had enablled the Extended Error Message by using AT+CMEE=1 Command, but this time also its response is ERROR oly for
AT+CNMI=0,0,2,0,0
>OK
AT+CSCB=0,"50","1"
>ERROR


Please thell is there any modification i need to do in this...
 

I don't have SIM900 modules and can't check the issue.
 

The AT+CENG command is what you need to use.

Cheers
 

Hi

Thanks for your reply, and finaly i had done the modification in AT Commands, now i am getting the Cell broadcast location by using the following Commands

AT+CMGF=1
>OK
AT+CNMI=2,0,2,0,0
>OK
AT+CSCB=0,"50","1"
>cell id my tower location
AT+CNMI=0,0,0,0,0
>OK

.....................
CHEERS
 

HI

According to Sim900 at commands manual the "AT+CSCB" command selects cell broadcast SMS Message, How do use it to get cell ID and tower location?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top