Terminator3
Advanced Member level 3
- Joined
- Feb 25, 2012
- Messages
- 802
- Helped
- 71
- Reputation
- 142
- Reaction score
- 63
- Trophy points
- 1,308
- Activity points
- 9,027
I am trying to do simple transient simulation in QUCS.
I loaded s2p component, AC source of 2GHz at port 1, and measure wave at port 2.
Using S-parameters simulation works well, and i can see s21 in smith chart. but when i do transient simulation, there is no any output on port 2. So i can see only input sine, and no any expected output sine... Anybody tried it?
I loaded s2p component, AC source of 2GHz at port 1, and measure wave at port 2.
Using S-parameters simulation works well, and i can see s21 in smith chart. but when i do transient simulation, there is no any output on port 2. So i can see only input sine, and no any expected output sine... Anybody tried it?
