Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CAN with PIC18F458 ? any working example?

Status
Not open for further replies.

balbes

Junior Member level 2
Joined
May 12, 2002
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
83
CAN with PIC18F458 ?

does anybody have working example on C ?

and another question - if the data I want to transceive is bigger than 8k, should I split it myself or the CAN controller will do it for me if I send it to him ?
 

Check Microchip application notes:
**broken link removed**

8kBytes? Standard defines max 8 data bytes in data message.
You have to split your data.

Check standards:

**broken link removed**
 

I find this on elektroda, so ...

regards
meax98
 

Excuse-me, if this sounds stupid. But I have one question.
What connectors are used for CAN bus and what is the pinout ?
I downloaded several docs about CAN, but there is no mention about physical layer and about connectors which are normally used for CAN bus.
 

Connectors and physical layer are custom :). Depends were are you
going to connect.

Typical transceivers are Philips TJA1050(newer) and PC82C250(older).
 

Very useful informations.
Thanks
:roll:
 

transceiver I use is MCP2551 ( product of microchip )
 

thanx for the information
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top