Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
CAN is a priority based message passing protocol where a single device can send a message to a number of receivers which are set up to accept the specified ID
however, there is nothing to stop one seting up a higher layer protocol where nodes have addresses and using a peer to peer protocol on top of CAN, e.g. much as one can run a ring protocol on a contention bus
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.