Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

CAM data convert to PCB file

Status
Not open for further replies.

jpbhatt

Junior Member level 3
Joined
Oct 27, 2007
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
india
Activity points
1,436
Dear all

I want to convert gerber data to pcb file pls. suggest.i am using protel 2.7

Thanks

JP
 

use eagle cadsoft easy cheap and free version is available . it generates CAM files . and views them . not so sure if can convert to PCB.

Also Altium Software . cadence orcad and mentor graphics . note these software are very expensive and hard to use.
 

I have seen this some one was doing using CAM350 tool..It is little bit difficult to convert Gerber to PCB..you need to model lot of things in cam tool to do this reverse engineering.
 

CAM350 is a good tool for reverse engineering although it is not easy for using. You can build parts but can't easy manage netlist.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top