Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Calibre Problem in Cadence

Status
Not open for further replies.

viks_iisc

Newbie level 4
Joined
Mar 20, 2009
Messages
6
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,316
I am using Calibre for DRC, LVS & PEX in Cadence. DRC and LVS are running fine but i am facing a weird problem in PEX. After extracting the parasitics and making a symbol and simulating it by including calibre view, its saying No DC path from some node(usually VDD) to ground. BUt schematic is working properly. The frequency of operation is also quite small, so i guess parasitics won't be affecting that much. :cry:
 

ams123

Newbie level 6
Joined
Apr 24, 2009
Messages
11
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,365
Hi there,

Sorry I could not answer your question. Instead, I got a question for you:
I extracted my circuit with calibre xRC, and set output as calibreview, extraction runs smoothly, however, I do not see calibreview shown in my cadence virtuoso schematic.
How can I make calibreview shown in cadence library?

Any idea?
Thank you
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top