calibre postsimulationof PEX netlist

[lhlbluesky]

calibre postsimulation

i extracted the PEX netlist (called A.pex.netlist), and how to do layout postsimulation with this PEX netlist?

if i use PEX netlist to replace the relative part of presimulation netlist, then how to do layout postsimulation with this PEX netlist?

if i use 'spectre input.scs' in terminal, then how to observe the waveform results (current or voltage waveforms), is results browser ok? or any other ways? should i use some related waveform observe tools? pls help me. thanks all.

 

[lhlbluesky]

calibre postsimulation

ideas?

 

[sudheerkm]

Re: calibre postsimulation

ok i donot know which tools u have

suppose u have eldo....
umay have the old silmulation files without pex

add vsources and output commands from those file(can be obtained from ur schematic editor output files)

and run eldo from command line.....
u cn view output
on ezwave or xelga

if u have cadence
things are easy goto hierarcy editor change the views
and run(but for that u should configure calibre from virtuoso