yhq0413
Junior Member level 1
I run calibre PEX with some warnings and errors
Warning: Not creating terminal GND in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal VDD in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal OUT in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal VIN in (vco calibre) since matching terminal was not found on schematic
error: could not find cell mapping for device n18_ckt-rf .Ignoring instance M0
error: could not find cell mapping for device p18_ckt-rf .Ignoring instance M1
the I/O type is inputoutput
I want to obtain an extracted view "caliber-view"
the process is SMIC 0.18 RF
virtuoso version is 5033.
Warning: Not creating terminal GND in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal VDD in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal OUT in (vco calibre) since matching terminal was not found on schematic
Warning: Not creating terminal VIN in (vco calibre) since matching terminal was not found on schematic
error: could not find cell mapping for device n18_ckt-rf .Ignoring instance M0
error: could not find cell mapping for device p18_ckt-rf .Ignoring instance M1
the I/O type is inputoutput
I want to obtain an extracted view "caliber-view"
the process is SMIC 0.18 RF
virtuoso version is 5033.